Talk:Cutter Types (Mill)
Jump to navigation
Jump to search
OWNER: Gatl2189 (talk) 21:22, 27 May 2013 (UTC)
Mentor Comments for 5/30/13[edit source]
- Description
- Put short description in proper place like Wikipedia does (see red text in page)
- Milling Machine Tooling Overview
- Consider renaming Different Mill Cutter to Milling Cutters
- Remove End Mills Section (collapse into 'Different Mill Cutter' section)
- Don't capitalize "Stock" in Gear Cutter description
- End Mills
- Move the description to Mill end out of the table and put it before the table as sort of an introduction
- Remove Mill end and 6 Flute End Mill from table
- Describe the 'Flute Diagram' in more detail
- "Rounded Edge End Mill" are also/typically know as "Bull Nose End Mills". Include this in your description.
- Consider renaming "Rounded Edge End Mill" to "Rounded Edge (Bull Nose) End Mill
- Facing Types
- Change Facing Types to "Cutters"
- Condense the three fly cutter pages(Square tool bit flat,Fly Cutter and the other one) and the into a single entry
- on Fly Cutter don't say that a fly cutterdoes not do as smooth of a job. This is not correct
- Cutter Material Identification/ Selection
- Change/ remove Lathe Speeds
- Add that Carbide is stiffer (doesn't deflect as much) and is better for hard materials
- Add section on Carbide and tools
Overall nice job. Check text for correctness and completeness.
Add section about centercutting and non-centercutting endmills selection and identification
Bowe6786 (talk) 21:54, 30 May 2013 (UTC)
Mentor Comments from 5/28/13[edit source]
- Description
- See Developers' Bulletin#Description for proper formatting and content
- Add an overview of the differences of the basic types of tools. For all types, refer to
- Include information about calculating speeds and feeds, reference machinist handbook or other sources as necessary
- End Mill Types
- Consider section title change to End Mills:
- Use Item/Setup table: Developers' Bulletin#Itemized/Step by step table
- include all cutters found here: http://www.mcmaster.com/#end-mills/=mycaju
- Add section for Cutters
- include all cutters found here: http://www.mcmaster.com/#standard-milling-cutters/=mye8wt
- Use Item/Setup table: Developers' Bulletin#Itemized/Step by step table
- Facing Types:
- Eliminate section, as it will be absorbed into Cutters
- Pictures
- Make sure the follow the guidelines found here: Developers' Bulletin#Guidelines for Pictures/Figures
- Make sure they are the correct orientation.
The above contents are mainly for formating, I will check content Wednesday. From a quick glance, the content looks mostly complete, but make sure to check with other sources such as the machinist book, McMaster, wikipedia, etc for a second check. Also, remove 'This is the...' as the name of the tool will be included image caption